Commit 1fc5ecab authored by David Pradas's avatar David Pradas

Update content of README.md

parent 6080150b
# Easy OpenSAND CLI
This is a small piece of software allowing to facility the setup of a minimal OpenSAND platform following a step-by-step approach.
Unlike to 'OpenSAND CLI' where you have to manualy run each commands, 'Easy OpenSAND CLI' groups commands by steps: configure/clean network and run/stop opensand binaries.
Technically, commands are grouped within makefiles and organized into Phony targets or recipes to be executed. Where a recipe consists to one or more actions to carry out.
This is a small piece of software allowing to make the setup of a minimal OpenSAND platform following easier. We invite to follow this step-by-step approach.
Unlike 'OpenSAND CLI' where you have to manualy run each command, 'Easy OpenSAND CLI' groups commands by steps: configure/clean network and run/stop opensand binaries.
Technically, commands are grouped within makefiles and organized into Phony targets or recipes to be executed. Where a recipe consists of one or more actions to carry out.
It provides for both modes, IP and ETH, makefiles to run on each component SAT, GW and ST.
It provides for both modes, IP and ETH, makefiles to run on each component: SAT, GW and ST.
## Pre-requisite
As with OpenSAND CLI, iproute2 and make packages are required. You can install them from your command line terminal by issuing
As with OpenSAND CLI, 'iproute2' and 'make' packages are required. You can install them from your command line terminal by issuing
```bash
apt-get install iproute2 make
```
......@@ -17,7 +17,7 @@ apt-get install iproute2 make
It is assumed that the simulation files are already configured and installed on each component, as well as this tool.
You need to modify each makefile to adapt them to your platform by correctly replacing variables value.
Once this done, you have to run makefiles as root from your command line terminal as follows:
Once this is done, you have to run makefiles as root from your command line terminal as follows:
```bash
make network
make run
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment