Commit 3eecdc6b authored by Francklin Simo's avatar Francklin Simo

Update README

parent feecaa63
# Easy OpenSAND CLI
This is a small piece of software allowing to facility the setup of a minimal OpenSAND platform following a step-by-step approach.
Unlike to 'OpenSAND CLI' where you have to manualy run each commands, 'Easy OpenSAND CLI' groups commands by step: configure/clean network and run/stop opensand binaries.
Unlike to 'OpenSAND CLI' where you have to manualy run each commands, 'Easy OpenSAND CLI' groups commands by steps: configure/clean network and run/stop opensand binaries.
Technically, commands are grouped within makefiles and organized into Phony targets or recipes to be executed. Where a recipe consists to one or more actions to carry out.
Its provides for both modes, IP and ETH, makefiles to run on each component SAT, GW and ST.
......@@ -14,7 +14,7 @@ apt-get install iproute2 make
```
## Usage
It is assumed that the simulation file are already configured and installed on each component, as well as this tool.
It is assumed that the simulation files are already configured and installed on each component, as well as this tool.
You need to modify each makefile to adapt them to your platform by correctly replacing variables value.
Once this done, you have to run makefiles as root from your command line terminal as follows:
......@@ -29,5 +29,5 @@ If needed, you can run
make network
make run
```
to respectively stop emualtion and clean network configurations.
to respectively stop emulation and clean network configurations.
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment