Commit 6080150b authored by Francklin Simo's avatar Francklin Simo

Fix OpenSAND CLI README

parent 3eecdc6b
......@@ -4,7 +4,7 @@ This is a small piece of software allowing to facility the setup of a minimal Op
Unlike to 'OpenSAND CLI' where you have to manualy run each commands, 'Easy OpenSAND CLI' groups commands by steps: configure/clean network and run/stop opensand binaries.
Technically, commands are grouped within makefiles and organized into Phony targets or recipes to be executed. Where a recipe consists to one or more actions to carry out.
Its provides for both modes, IP and ETH, makefiles to run on each component SAT, GW and ST.
It provides for both modes, IP and ETH, makefiles to run on each component SAT, GW and ST.
## Pre-requisite
......@@ -22,12 +22,14 @@ Once this done, you have to run makefiles as root from your command line termina
make network
make run
```
First command configure network interfaces and routing, and second one run OpenSAND binary.
First command configures network interfaces and routing, and second one runs OpenSAND binary.
If needed, you can run
```bash
make network
make run
make stop
make clean
```
to respectively stop emulation and clean network configurations.
## Now, you can enjoy it!
.
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment